My eBoost
Super - fast cutting of thin and medium sheets up to approximately 6mm (.240”) thick (material and laser power dependent). My eBoost has 2 primary functions:

My eFly - My eFly cutting involves the piercing of relatively thin material while at cutting speed as opposed to stopping, piercing, and then moving. The head moves between the contours arranged in an array with an equal speed, not slowing down to pierce, and the cutting is done by switching the laser beam on while over the cutting lines and off as it passes between the contours. When your part has an appropriate repetitive pattern, Flycut can greatly decrease part cycle time and is used up to a thickness of 6 mm.

My eFast – eFast involves “piercing on the fly” and greatly reduces pierce time. Instead of a stationary pierce, the system moves at an appropriate rate to decrease pierce time, and then resumes full speed as soon as possible. This option is used to cut sheets up to thickness of 12mm. With this option, the cutting efficiency of thin and medium sheets improves by up to 30%.

Fast cutting of thin and medium thickness sheets

Super - fast cutting of thin and medium thickness sheets up to approximately 6mm (.240”) thick (depending on the material and the laser power). Fastline has 2 primary functions:

• FlyCut - Fly cutting involves the piercing of relatively thin material at cutting speed, as opposed to stopping, piercing, and then moving. The head moves between contours arranged in an array at a constant speed without stopping to pierce. Cutting takes place by switching on the laser beam above the cutting lines and switching it off again between contours. If your part has an appropriate repetitive pattern, Flycut can significantly reduce the throughput time of the part, and can be used up to a thickness of 6 mm.

• FastCut – Fastcut involves “piercing on the fly” and significantly reduces the piercing time. Rather than stationary piercing, the system moves at an appropriate speed to reduce the piercing time, and then resumes at full speed as soon as possible. This option is used to cut sheets with a thickness of up to 12mm. This option improves the cutting efficiency of thin and medium thickness sheets by up to 30%.

Contact